Service Page 5: Assembly Switch action rags to protect your fingers or hands when removing or installing the blades. Failure to do so may result in Page 6 1. Inside edge of 1. Pan head screw gauge plate 2. Adjusting plate 2. Blade edge 3. Planer blade 3. Planer blade locating lugs 4. Adjusting plate 4. Gauge plate 5. Screws 5. Heel of 6. Heel adjusting plate 7.
Back side of 6. Page 7: Correct Setting EN For tools with European type round chip cover Connecting a vacuum cleaner When you wish to perform clean planing operation, connect a Makita vacuum cleaner to your tool as shown 1. European type in the figure. Page 8: Planing Operation 2. Start A nozzle and joint optional accessories are necessary to connect a Makita vacuum cleaner to your tool. Consult a Makita catalogue or representative on the nozzle and First, rest the tool front base flat upon the workpiece joint.
Page 9: Maintenance Adjust the edge fence until it comes in contact with the 1. V groove side of the workpiece, then secure it by tightening the screw. Screw 2. Page Optional Accessories attachment for its stated purpose. This could cause an injury. Page 8 9. Check the three hex flange head bolts for final tightness. Repeat procedures 1 - 9 for other blade. For the correct planer blade setting Your planing surface will end up rough and uneven, unless the blade is set properly and securely.
The blade must be mounted so that the cutting edge is absolutely level, that is, parallel to the surface of the rear base. Page 9: Operation The speed and depth of cut determine the kind of finish. The power planer keeps cutting at a speed that will not result in jamming by chips.
For rough cutting, the depth of cut can be increased, while for a good finish you should reduce the depth of cut and advance the tool more slowly. Page 10 1. Blade edge 2. Cutting line 1. Screw 2. Edge fence Draw a cutting line on the workpiece. Insert the edge fence into the hole in the front of the tool. Align the blade edge with the cutting line. Adjust the edge fence until it comes in contact with the side of the workpiece, then secure it by tightening the screw.
Page Maintenance 1. Limit mark 1. Chip cover 2. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose. Makita U. Page 14 Paste 3. Be sure to attach a letter to the outside of Model No. Print page 1 Print document 17 pages. Rename the bookmark. Delete bookmark? Cancel Delete. Delete from my manuals?
Sign In OR. Don't have an account?
0コメント